Bottom case set for double servo for KRS-6000 / 9000 series

A bottom case set for combining the KRS-6000 / 9000 series with a double servo.
The screws and pins required for the combination are included.
* There is no set of 6 pieces.

[Set contents]
● Bottom case 6000/9000 (with flange) x 2
● M2.6-10 screw x 4
● Nut x 4
● Knock pin x 3

[Material]
● Resin

[Compatible models]
● KRS-6003 / 6003R / 6003R2HV
● KRS-9004HV

[Differences from conventional products]
The difference between the conventional No.02029 and this product No.02240 is the bulge inside the case.
In No02029, this bulge interferes with the KRS-9000 series board, but
No.02240 of this product prevents interference by lowering the bulge.
Please note that No.02029 cannot be installed on the KRS-9000 series.

This product No.02240 can also be used for the KRS-6000 series.
The conventional No.02029/02030 will be discontinued.
We look forward to your continued support of No. 02240.